Slab Leak Detection & Repair in Tyler, TX
Three questions usually settle a slab leak before the meter test even runs. Has the water bill climbed with no change in habits? Is there a warm patch on the floor that was not there last month? Can you hear water moving with every fixture off? Two yes answers and we are almost certainly chasing a line under your slab.
Prefer to talk first? Call (903) 651-5125 and describe what you are seeing.
What a slab leak actually is
A slab leak is a failure in a water line that runs through or beneath the concrete slab your home sits on. Most of Tyler past the 1950s was built this way, with copper supply lines cast into the pour or laid in the gravel bed underneath. When one of those lines cracks, the water has nowhere to go but into the soil and up through the slab.
The reason it matters so much here comes down to the ground. Tyler sits on expansive clay, the heavy "black gumbo" that swells when wet and shrinks when dry. That seasonal movement drags the slab and the pipe with it, and a copper line bonded to a shifting slab eventually shears at a joint or a bend. Homes built between the 1960s and 1990s with original copper are the ones we see fail most often.
How we locate it without breaking up the floor
Detection is the part that protects your home. We start by confirming the leak with a pressure test and a meter check, so there is no guessing about whether water is escaping. From there we listen. Acoustic sensors pick up the high pressurized hiss a supply leak makes, and on a quiet slab that sound leads us within a few inches of the spot.
When the leak is slow or the line is hot water, we add tools. Tracer gas finds the leaks too small to hear, and thermal imaging reads the warm shadow a hot-water line throws behind tile or under carpet. By the time we mark the floor, we know where the failure sits, not just the room it is in.
Repair options once we find it
The right repair depends on what the detection turns up. A single failure in an otherwise sound line usually calls for a spot repair: we open one small section of slab directly over the leak, replace the damaged length of pipe, pressure test it, and patch the concrete. One cut instead of a torn-up room.
When the line shows widespread corrosion or the home has already had a slab leak or two, rerouting or a repipe is the more honest fix. We run new lines above the slab so the old under-slab run is taken out of service entirely. We walk you through the trade-offs and the cost of each before anything starts.
How a Tyler slab-leak visit goes
The visit is shorter than most people expect. When you call (903) 651-5125, we ask what you are seeing so the right gear comes on the truck. On site, the first step is isolation: we close off the system and watch the meter to confirm the loss, then start narrowing by zone, hot side versus cold side, room by room.
Once the zone is clear, the listening starts. We move the acoustic sensor across the slab and follow the loudest point, cross-checking with tracer gas or thermal imaging where the line runs deep or the floor is covered. When the mark goes down on the floor, it is a spot, not a guess. Most detections wrap inside a couple of hours.
What the repair costs depends on access more than anything. A leak under an open tile floor is one job; a leak beneath a kitchen island or a built-in is another. We give you the number for the detection and the repair before any concrete is touched, so the decision is yours with the full picture in front of you.
What it means for a Tyler home left alone
A slab leak does not heal. Water under the slab erodes the soil support, feeds mold within a couple of days in Tyler humidity, and over months can move the foundation enough to crack tile and drywall. The bill keeps climbing the whole time. Catching it early near Hollytree or anywhere off Loop 323 is the difference between a small patch and a foundation conversation.
Warm spot on the floor?
Talk it through with a licensed Tyler leak specialist, any hour.
☎ (903) 651-5125Questions Tyler homeowners ask
How do I know it is the slab and not something above ground?
A warm spot on the floor, a foundation that sounds hollow, and a meter that creeps with every tap off all point below the slab. We confirm it with a pressure test before opening anything, so you are not paying to chase the wrong thing.
Will you have to jackhammer my whole floor?
Almost never. Once we pinpoint the leak, the repair opens one small section over the failure. The detection work is what keeps that hole small.
Is a slab leak covered by homeowners insurance?
Policies differ, but many cover the resulting water damage even when they exclude the pipe itself. Document the spike and the damage, and call (903) 651-5125 so we can give you the detection findings in writing.
Keep going ☎ (903) 651-5125
Find it first. Then fix it.
One call gets a licensed Tyler leak specialist on the line, 24 hours a day.
☎ (903) 651-5125